Changement nacelle DJI Mini 3 Pro

Rédigé par : Arty
  • Commentaires : 10
Changement nacelle DJI Mini 3 Pro

Difficulté

Modérée

Étapes

0

Temps nécessaire

1 - 2 heures

Introduction

Voici un tutoriel pour changer votre module nacelle ou le le boîtier nacelle DJI Mini 3 Pro.

Après avoir changé la nacelle et remis en place la caméra, vous devez re-calibrer votre drone. Il est impossible pour cela d'utiliser l’appli DJI Fly mobile, il vous faut un logiciel supplémenataire. Voici une vidéo explicative de calibrage : https://youtu.be/mu03HWXplM4

Conclusion

Pour remonter l’appareil, suivez ces instructions.

Auteur

Arty

Membre depuis le 27/10/19

26675 Réputation

10 commentaires

Does anyone have a source for replacing the little rubber gimbal mounts?

Andre Purdy -

HI there! Does anyone know where I can buy the whole gimbal in USA? I remember seeing it somewhere but cannot find it

gbonilla -

Go to YouTube and check the link to the gimbal assembly in the description below the video

Arty -

mini 3 pro com port not show on device manegar any help.

Limon Khan -

Start trembling during flight after a horizontal stop. At the start, I can hear the gimbal noise from trembling (before taking off). I gently touch it, and it stops. I take off and fly a long distance.

If I stop it or it stops it by signal loss, the trembling starts again. if I never stop it and take gentle curves back, it may work. At abrupt stops, it starts trembling. I bring the drone back to me at 1-meter height. I gently touch the gimbal (without landing), and it stops. Then I fly again (if the battery is low, I land, change the battery, and start again, same steps, every time). I will probably buy a new one, so I can send this to repairs - did not check the guarantee yet.

- no problems during climbing up.
- only on horizontal movements and hard stops (release the lever on the controller).
I will try never to release the lever abruptly and never lose signal (a signal lost could be a hard brake, also)
??? Calibration can stop this strange error ????

Dorin -

Check the metal piece of the gimbal to make sure it is not broken anywhere. That can cause the camera to vibrate.

Frankie Snaps -

bonjour,

ou peut on trouver la piece neuve ?

Cédric Rovelli -

Hey what parts do I need to get and where to get them from in au. I crashed and it’s broken the right side of the gimbal completely off. The camera still looks fine and working but there is a cable snapped off. any help would be much appreciated

Brody D -

I don't know how to get the parts in AU, but I just had the same problem and fixed it. If the motors still rotate, then it shouldn't be too hard (or expensive) to fix. I just replaced the cable, the plastic covering and the rubber dampeners, and it worked. This was the video that was really helpful.

https://youtu.be/fiebNX5f1r8?feature=sha...

MJT -

There was no link to order the Gimbal replacement part???

citsalllc -